In this tutorial we will understand how we can sketch the Spline and Ellipse in Creo parametric sketch. Let’s start this tutorial.

Table of Content

The Ellipse Tool

In Creo Parametric sketch, use of the ellipse tool is almost the same as the circle tool. the only difference is that we need to define major and minor axis.there are two ways to make an ellipse and they are as follow:

  • Ends and axis
  • Center and Axis

Axis and Ends Ellipse

First select axis and ends ellipse option then make a click in sketching plane. This will be the starting point of your axis. Now make a suitable length of axis and click again to make the end point of axis. The method of sketching axis is just like sketching a line. Now move the mouse cursor about the axis, you have just made, and you will see an ellipse is being generated in this cad software.

ends axis ellipse in creo elements pro

Center and Axis Ellipse

In this option you have to define center and lengths of each axis (minor and major) by clicking at desired locations. First select Center and Axis Ellipse option, make first click at desired location where you want to place the center of Ellipse and move the cursor along any direction within suitable range of length and make second click. This will create first axis of Ellipse. Now move the cursor about the first axis and you will see the ellipse in dotted form. to draw second axis make the third click at desired location. In the following fig (left) the cross sign “x” is pointed to the center of ellipse and location of cursor is defining the end of Major Axis. while on the right location of cursor in pointing to the end of minor Axis.

center-axis ellipse in creo elements pro

Spline Tool

This tool enable us to make a curve passing through series of points. We have a choice to place these points. To perform its exercise all we need to select the Spline toolSpline-tool in Sketching Window and then make successive points by left clicking in sketching window. a curve will start to appear and will change when you create next point.

Spline-excercise

Share it



updated on

by

One response to “How to Use Ellipse and Spline tools in Creo Parametric Sketch”

  1. Peeru babu Avatar
    Peeru babu

    How to create elipse in creo
    Give me the full topic
    Plz

Leave a Reply to Peeru babu Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.